Why Samsung sl m2670fn needs to be reset:
– Samsung sl m2670fn’s cartridge is work with a toner cartridge chip that was using for count toner coverage and to deliver bold or light printout quality depending on Samsung sl m2670fn printer original printout design.
– Samsung printer toner cartridge chip contains counted limitation that was managed by Samsung. Samsung think if toner coverage is 7 percent, Samsung sl m2670fn toner chip is in range 3.000 – 15.000 print page.
– If Samsung sl m2670fn toner cartridge coverage is over 5% -> Toner Page Yields are less than “3.000 near 15.000” print pages. If toner coverage is lower than 5 percent, Toner Page Yields are “3.000 to 15.000” times That is the reason why bold printouts (high toner coverage) will make printers run out of toner quicker.
– When Samsung sl m2670fn toner chip overload its figure out restriction, printer will be locked inspire of high toner cartridge.
What is message Samsung sl m2670fn printer needs to be adjust?
- Samsung sl m2670fn printer’s errors: red light blinking, imprinting.
- Computer’s messages: empty toner, Regenerate toner, installing toner, end of life renew new cart , toner cartridge is not installed, Install the cartridge, toner exhausted.
Solution to mend Samsung sl m2670fn with imprinting error:
We have 3 set right to adjust your Samsung sl m2670fn printers.
Remedy 1. Change new toner cartridge for Samsung sl m2670fn printer
– Samsung sl m2670fn’s toner cartridge cost about $60 – $192 depending on its supplier & manufacturer.
– Remove old toner and operate new toner cartridge seems to be suboptimal because when printer runs out of toner, we also must be change new Samsung sl m2670fn toner cartridge => money wasting
Solution 2. Change new toner chip for Samsung sl m2670fn’s toner cartridge
– Samsung sl m2670fn’s toner chip Fee $5 => $22 depending on its supplier.
– Changing toner cartridge chips seems to be more optimal but when printers runs out of toner, we also need to change new toner chip.
Remedy 3. adjust permanently Samsung sl m2670fn by using firmware adjust
– Samsung sl m2670fn’s adjust software cost around $10 – $20 USD (almost cost around $14)=> saving money
– adjust freeware automatically impacts to printer firmware so printers ignores paper counters. Therefore, there is not necessary to change toner chip, you just refill toner when it runs out.
Have a nice day
