Why Samsung ml 2950nd needs to be reset:
– Samsung ml 2950nd’s cartridge have a toner cartridge chip that was used for calculate toner coverage and to deliver bold or light printoutquality depending on Samsung ml 2950nd printers original printout design.
– Samsung ml 2950nd printer toner cartridge chip contains counted limitation that was managed by Samsung manufacturer. Following Samsung, if toner coverage is 4%, Samsung ml 2950nd toner cartridge chip is about 3.000 – 15.000 sides
– If Samsung ml 2950nd toner cartridge coverage is rather 5 percent -> Toner Page Yields are less than “3.000 or 15.000” pages. If toner coverage is lower than 7 percent, Toner Page Yields are “3.000 near 15.000” sides That is the reason why bold printouts (high toner coverage) will make printer run out of toner more quickly.
– If Samsung ml 2950nd toner cartridge chip overload its calculated restriction, Samsung ml 2950nd will be locked inspire of high toner cartridge.
When Samsung ml 2950nd needs to be reset?
- Samsung ml 2950nd printer’s errors: red light flashing, imprinting.
- Computer’s messages: empty toner, Regenerate toner, install toner, end of life renew new cart , toner cartridge is not setup, Installing the cartridge, toner exhausted.
How to fix Samsung ml 2950nd with imprinting problem:
You have 3 answer to fix your Samsung ml 2950nd printers.
Remedy 1. Change new toner cartridge for Samsung ml 2950nd printer
– Samsung ml 2950nd’s toner cartridge costs around $84 – $201 depending on its supplier & manufacturer.
– Replace toner cartridge seems to be suboptimal because when printer runs out of toner, we also need to change new toner cartridge => money wasting
Remedy 2. Change new toner chip for Samsung ml 2950nd’s toner cartridge
– Samsung ml 2950nd’s toner cartridge chip price $7 -> $24 depending on its supplier.
– Changing toner chips seems to be more optimal but when printers runs out of toner, we also must be change new toner cartridge chip.
Way 3. adjust permanently Samsung ml 2950nd by using firmware reset
– Samsung ml 2950nd’s reset software costs about $11 – $60 USD (almost cost around $11)=> save your money
– reset software automatically impacts to printer firmware so printers ignores paper counter. Therefore, there is not necessary to change toner cartridge chip, you just refill toner when it runs out.
Have Fun
