Why Samsung ml 2160 printer needs to be adjust:
– Samsung ml 2160 toner cartridge is work with a toner chip that was using for calculate toner coverage and to deliver bold or light printout quality depending on Samsung ml 2160 printers original printout design.
– Samsung ml 2160 printer toner cartridge chip contains counted restriction that was managed by Samsung. Following Samsung, if toner coverage is 7%, Samsung ml 2160 toner cartridge chip is enabled 3.000 – 15.000 sides
– If toner cartridge coverage is rather 7% -> Toner Page Yields are less than “3.000 : 15.000” print page. If toner coverage is lower than 4%, Toner Page Yields are “3.000 or 15.000” pages. That is the reason why bold printouts (high toner coverage) will make printer proceed out of toner quicker.
– If Samsung ml 2160 toner chip overload its figure out limitation, Samsung ml 2160 printer will be locked inspire of high toner cartridge.
What is message Samsung ml 2160 must to be adjust?
- Samsung ml 2160 printer’s show alert: red light blinking, imprinting.
- Computer’s messages: empty toner, Regenerate toner, installing toner, end of life regenerate new cart , toner cartridge is not Install, Installing the cartridge, toner exhausted.
Have three solution to restore Samsung ml 2160 with imprinting problem:
We have 3 remedy to repair your Samsung ml 2160 printer.
Way 1. Replace toner cartridge for Samsung ml 2160 printer
– Samsung ml 2160’s toner cartridge Pay around $83 – $210 depending on its supplier & manufacturer.
– Changing toner cartridge seems to be suboptimal because when printer runs out of toner, we also must be change new toner cartridge => money wasting
Remedy 2. Replace toner chip for Samsung ml 2160’s toner cartridge
– Samsung ml 2160’s toner chip Pay $8 ~ $24 depending on its supplier.
– Changing toner chips seems to be more optimal but when printers runs out of toner, we also need to change new toner chip.
Way 3. reset permanently Samsung ml 2160 by using software reset
– Samsung ml 2160’s reset middleware cost about $12 – $90 USD (almost Pay about $10)=> money saving
– adjust software automatically impacts to printer firmware so printers ignores paper counters. Therefore, there is not necessary to change toner chip, you just refill toner when it runs out.
do this topic helpful for you?
