Reason Samsung ml 1866 printer needs to be reset:
– Samsung ml 1866 toner cartridge is enclosed with a toner cartridge chip that was using to figure out toner coverage & to deliver bold or light printout quality depending on Samsung ml 1866 printer original printout design.
– Samsung ml 1866 printer toner chip contains counted limitation that was managed by Samsung manufacturer. Samsung think if toner coverage is 6 percent, Samsung ml 1866 toner cartridge chip is limited 3.000 – 15.000 pages.
– If toner coverage is over 6 percent -> Toner Page Yields are less than “3.000 ~ 15.000” sides If toner coverage is lower than 7%, Toner Page Yields are “3.000 : 15.000” sides That is the reason why bold printouts (high toner coverage) will make printer proceed out of toner more quickly.
– If Samsung ml 1866 toner cartridge chip overload its figure out restriction, Samsung ml 1866 will be locked inspire of high toner cartridge.
What is message Samsung ml 1866 printer must to be reset?
- Samsung ml 1866 printer’s errors: red light blinking, imprinting.
- Computer’s messages: empty toner, Change toner, install toner, end of life renew new cart , toner cartridge is not Install, Install the cartridge, toner exhausted.
Remedys to restore Samsung ml 1866 with imprinting error:
You have 3 remedy to repair your Samsung ml 1866 printer.
Way 1. Change new toner cartridge for Samsung ml 1866 printer
– Samsung ml 1866’s toner cartridge costs around $50 – $201 depending on its supplier and manufacturer.
– Changing toner cartridge seems to be suboptimal because when printer runs out of toner, we also must be replace Samsung ml 1866 toner cartridge => money wasting
Solution 2. Replace toner cartridge chip for Samsung ml 1866’s toner cartridge
– Samsung ml 1866’s toner cartridge chip Fee $6 -> $22 depending on its supplier.
– Changing toner chips seems to be more optimal but when printer runs out of toner, we also need to change new toner cartridge chip.
Way 3. adjust permanently Samsung ml 1866 by using software adjust
– Samsung ml 1866’s reset software cost about $10 – $20 USD (almost cost around $10)=> saving money
– adjust freeware automatically impacts to printers firmware so printer ignores paper counter. Therefore, there is not necessary to change toner cartridge chip, you just refill toner when it runs out.
Good luck!
